Spicer Kingpin Bushing and Seal Installation Instructions Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Para o carro Spicer Kingpin Bushing and Seal Installation Instructions. Spicer Kingpin Bushing and Seal Installation Instructions User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 2
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
P/N: SHAIS130
Kingpin Bushing and Seal Installation Instructions
Models:
E-1000I E-1200I E-1320I E-1460I EFA-12F3, EFA-12F4 EFA-22T2
E-1000W E-1200W E-1320W E-1460W EFA-13F3, EFA-13F5 EFA-22T5
E-1201W E-1462I EFA-18F3, EFA-20F4 EFA-24T2
EFA-24T5
Some Dana bushings require reaming after installation. This kit contains “pre-sized” kingpin bushings
that do not require reaming. Follow the proper installation instructions provided with the parts.
Below are the installation instructions for kingpin bushing and seal replacement only. Refer back to the
proper service manual for detailed instructions on the disassembly and assembly of all other steer axle
components.
Installation Steps:
1. Remove the old grease seals from the knuckle kingpin bores with a suitable tool.
2. Drive bushings out of knuckle with the proper Removal/Installation tool.
3. Remove all foreign material from kingpin areas of the steering knuckle and axle beam.
4. Wire brush machined surfaces taking care not to damage them. Clean kingpin bore.
5. When installing the bushings lightly lubricate the outside diameter to make installation easier.
6. Hand start the bushing in the beam bore.
Note: When installing kingpin bushings, position the seam in areas marked “X”. (See Figure 1)
Figure 1
Spicer
®
Axles & Brakes
Vista de página 0
1 2

Resumo do Conteúdo

Página 2 - Figure 3

7. Drive bushing until they are located at the depth indicated on figure 2. Use the same method to install both top and bottom bushings.

Comentários a estes Manuais

Sem comentários